Concept Guide

show ip health-check
Description
Display the health-check status of the uplink interfaces of a branch-office controller.
Syntax
No parameters.
Example
The following example displays the status of two uplinks on a branch controller.
(host) #show ip health-check
IP Health-Check Entries
-----------------------
Probe IP Src Interface State Probe-Profile Avg Delay(ms) Jitter
-------- ------------- ------ -------------- ------------- ------
192.168.100.1 vlan 4094 Up health-check 0.237 0.038
The output of this command includes the following data columns.
Parameter Description
Probe IP
IP address of the master controller.
Src Interface
IP address of the uplink gateway interface through which the probes were
sent.
State
Shows if the uplink is in an UP or DOWNstate.
Probe-Profile
A branch controller supports the default probe profile to define probe set-
tings for policy-based routing using next-hop lists, and the health-check
probe profile to define probe settings to measure WAN uplink health.
delay (in ms)
The average delay on the interface, in milliseconds.
Related Commands
Command Description
ip probe default This command configures IP probes for policy-based routing using a next-
hop list.
ip probe health-check This command configures WAN health-check probes for measuring WAN
availability and latency on branch controller uplinks.
Command History
Release Modification
ArubaOS 6.4.3 Command Introduced
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ip health-check | 1595