Concept Guide

Parameter Description
Note:When NTP server is reachable through IPv4 address, use the address
as is. If done through IPv6 address, the Reference ID is calculated instead
of directly taking the IPV6 address on the NTP Server. The controller
performs a MD5 checksum and the last 4 bytes are considered as the
reference ID.
reference time Time when the local system clock was last set or corrected, in NTP
timestamp
format.
system flags This parameter displays any flags configured for this NTP entity.
jitter The average magnitude of jitter between several time queries.
stability The average magnitude of offset between several time queries
broadcastdelay The broadcast delay of this NTP server association, in seconds.
authdelay The authentication delay of this NTP server association, in seconds.
Related Commands
To configure an NTP server, use the command ntp server.
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 6.4 The following parameters were introduced:
l time since restart
l packets received
l packets processed
l current version
l previous version
l declined
l access denied
l bad length or format
l bad authentication
l rate exceeded
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ntp status | 1753