Concept Guide

Table Of Contents
show poe
show poe [slot/port]
Description
Displays the PoE status of all or a specific port on the controller.
Syntax
No parameters.
Example
The output of this command shows the PoE status of port 10 in slot 1.
(host) # show poe 1/10
PoE Status
----------
Port Status Voltage(mV) Current(mA) Power (mW)
---- ------ ----------- ----------- ----------
FE 1/10 Off N/A N/A N/A
Command History
This command was available in ArubaOS 3.0
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config or Enable mode on master or
local controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show poe | 1773