Concept Guide

Table Of Contents
show startup-config
show startup-config
Description
Displays the configuration which will be used the next time the controller is rebooted. It contains all the
options last saved using the write memory command. Any unsaved changes are not included.
Syntax
No parameters.
Example
The output of this command shows slot details on the controller.
(host) # show startup-config
version 3.4
enable secret "608265290155fb924578f15b12670a75a37045cbdf62fb0d3a"
telnet cli
telnet soe
loginsession timeout 30
hostname "FirstFloor2400"
clock timezone PST -8
location "Building1.floor1"
mms config 0
controller config 22
ip access-list eth validuserethacl
permit any
!
netservice svc-snmp-trap udp 162
netservice svc-dhcp udp 67 68
netservice svc-smb-tcp tcp 445
netservice svc-https tcp 443
netservice svc-ike udp 500
netservice svc-l2tp udp 1701
netservice svc-syslog udp 514
...
...
...
netservice svc-msrpc-udp udp 135 139
netservice svc-ssh tcp 22
netservice svc-http-proxy1 tcp 3128
--More-- (q) quit (u) pageup (/) search (n) repeat
Command History
This command was available in ArubaOS 3.0
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show startup-config | 1903