Concept Guide

vrrp
vrrp <id>
advertise <interval>
authentication <password>
description <text>
holdtime <secs>
ip address <ipaddr>
no...
preempt
priority <level>
shutdown
tracking interface {fastethernet <slot>/<module>/<port>|gigabitethernet
<slot>/<module>/<port>}
{sub <value>}
tracking master-up-time <duration> add <value>
tracking vlan <vlanid> {sub <value>}
tracking vrrp-master-state <vrid> add <value>
vlan <vlanid>
vrrp ipv6 <id>
advertise <interval>
description <text>
holdtime <secs>
ipv6 address <ipaddr>
no...
preempt
priority <level>
shutdown
tracking interface {fastethernet <slot>/<module>/<port>|gigabitethernet
<slot>/<module>/<port>}
{sub <value>}
tracking master-up-time <duration> add <value>
tracking vlan <vlanid> {sub <value>}
tracking vrrp-master-state <vrid> add <value>
vlan <vlanid>
Description
This command configures the Virtual Router Redundancy Protocol (VRRP).
Syntax
Parameter Description Range Default
id
Number that uniquely identifies
the VRRP instance, also known
as the VRID. This number should
match the VRID on the other
member of the redundant pair.
For ease in administration, you
should configure this with the
same value as the VLAN ID.
After you configure the VRID, the
command platform enters VRRP
mode. From here, you can
access the remaining VRRP
commands.
1-255 —
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide vrrp | 2234