Concept Guide

Parameter Description Range Default
controller. APs in decrypt-
tunnel forwarding mode
also manage all 802.11
association requests and
responses, and process all
802.11e and 802.11k action
frames.
NOTE: Virtual APs in bridge or
split-tunnel mode using static
WEP should use key slots 2-4 on
the controller. Key slot 1 should
only be used with Virtual APs in
tunnel mode.
ha-disc-onassoc
If enabled, home agent
discovery is triggered on client
association instead of home
agent discovery based on traffic
from client. Mobility on
association can speed up
roaming and improve
connectivity for clients that do
not send many uplink packets to
trigger mobility (VoIP clients).
Best practices is to leave this
parameter disabled, as it
increases IP mobility control
traffic between controllers in
the same mobility domain.
Enable this parameter only
when voice issues are observed
in VoIP clients.
NOTE: ha-disc-onassoc
parameter works only when IP
mobility is enabled and
configured on the controller.
— disabled
hs2-profile
Enables or disables a hotspot
profile. This is enabled by
default.
— enabled
mobile-ip
Enables or disables IP mobility
on a virtual AP. This is enabled
by default. L3 mobility service is
active on a VAP only if router
mobile is also enabled on the
controller.
— enabled
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide wlan virtual-ap | 2366