Concept Guide

ap-move
ap-move
all
ap-group <ap-group>
ap-name <ap-name>
Description
When HAis enabled, use this command to move an AP or group of APs to their standby controller.
Syntax
Parameter Description
all
Move all APs.
ap-group <ap-group>
Move all APs belonging to the specified AP group.
ap-name <ap-name>
Move the specified AP.
Usage Guidelines
When HAis enabled on a pair of controllers, this command should be used when it is necessary to move a
single AP, all APs in an ap-group, or all APs to switchover to their standby controller without an actual failure of
the active controller. For example, this allows the network admin to manually move one or more APs to their
standby controller and perform a planned upgrade or maintenance on the active controller.
Command History
Introduced in ArubaOS 6.3.
Command Information
Platforms Licensing Command Mode
Available on all platforms. Base operating system Enable mode on master or local
controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ap-move | 241