Concept Guide

boot
boot
cf-test [fast | read-only | read-write]
config-file <filename>
remote-node [all|ip-address <A.B.C.D]
system partition [0 | 1]
verbose
Description
Configure the boot options for the controller.
Syntax
Parameter Description
cf-test
Sets the type of compact flash test to run when booting the controller.
fast
Performs a fast test, which does not include media testing.
read-only
Performs a read-only media test.
read-write
Performs a read-write media test.
config-file
Sets the configuration file to use when booting the controller.
<filename>
Specifies the name of the configuration file from which to boot the controller.
remote-node
Reloads a branch controller.
all
Reloads all branch controllers on the network.
ip address
<A.B.C.D>
Reloads the branch controller with the specified IPaddress.
system 0 | 1
Enter the keyword system followed by the partition number (0 or 1) that you
want the controller to use during the next boot (login) of the controller.
NOTE: A controller reload is required before the new boot partition takes
effect.
verbose
Prints extra debugging information at boot.
Usage Guidelines
Use the following options to control the boot behavior of the controller:
l cf-test—Test the flash during boot.
l config-file—Set the configuration file to use during boot.
l system—Specify the system partition to use during the controller’s next boot (login).
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide boot | 259