Concept Guide

Table Of Contents
configure terminal
configure terminal
Description
This command allows you to enter configuration commands.
Syntax
No parameters.
Usage Guidelines
Upon entering this command, the enable mode prompt changes to:
(host) (config) #
To return to enable mode, enter Ctrl-Z or exit.
Example
The following command allows you to enter configuration commands:
(host) # configure terminal
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable mode on master controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide configure terminal | 289