Concept Guide

control-plane-security
control-plane-security
auto-cert-allow-all
auto-cert-allowed-addrs <ipaddress-start> <ipaddress-end>
auto-cert-prov
cpsec-enable
no ...
Description
Configure the control plane security profile by identifying APs to receive security certificates.
Syntax
Parameter Description
auto-cert-allow-all
When you issue the control-
plane-security auto-cert-allow-
all command, the controller will
send a certificate to all
associated APs when auto
certificate provisioning is
enabled. When disabled, the
controller sends certificates only
to APs whose IP addresses are in
the ranges specified by auto-
cert-allowed-addrs.
auto-cert-allowed-addrs <ipaddress-start> <ipaddress-end>
Use this command to define a
specific range of AP IP
addresses. The controller will
send certificates to the APs in
this IP range when auto
certificate provisioning is
enabled. Identify a range by
entering the starting IP address
and the ending IP address in the
range, separated by a single
space. You can repeat this
command as many times as
necessary to define multiple IP
ranges.
auto-cert-prov
Issue this command to enable
automatic certificate
provisioning. When this feature is
enabled, the controller will
attempt to send certificates to
associated APs. To disable this
feature, use the command no
auto-cert-prov. Automatic
certificate provisioning is
disabled by default
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide control-plane-security | 290