Concept Guide

Table Of Contents
controller-ipv6
controller-ipv6 [loopback|{vlan <VLAN ID>}]
no ...
Description
This command sets the default IPv6 address of the controller to the IPv6 loopback interface address or a
specific VLAN interface address.
Syntax
Parameter Description Default
loopback
Sets the controller IP to the loopback interface. disabled
vlan
Set the controller IP to a VLAN interface.
VLAN ID
Specifies the VLAN interface ID.
Usage Guidelines
This command allows you to set the default IPv6 address of the controller to the IPv6 loopback interface
address or a specific IPv6 VLAN interface address. If the controller IPv6 command is not configured then the
controller IP defaults to the loopback interface address. If the loopback interface address is not configured
then the first configured VLAN interface address is selected. Generally, VLAN 1 is the factory default setting
and thus becomes the controller IP address.
Example
The following command sets the controller IP address to VLAN interface 6.
(host) (config) #controller-ipv6 vlan 6
Related Commands
(host) (config) #show controller-ipv6
Command History
This command is introduced in ArubaOS 6.1.
Command Information
Platform License Command Mode
Available on all platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide controller-ipv6 | 293