Concept Guide

Parameter Description Range Default
However, if you execute the
trusted vlan <word>
command, it overrides any
earlier untrusted VLANs or a
range of untrusted VLANs and
creates a new set of trusted
VLANs.
NOTE: A port supports a user
VLAN range from 1-4094. If
you want to set all VLANs (1-
4094) on a port as untrusted
then mark the port itself as
untrusted. By default the port
and all its associated VLANs
are trusted.
tunneled-node-port
Enable or disable tunneled
node capability on the port.
— Disabled
xsec
Enables and configures the
Extreme Security (xSec)
protocol.
NOTE: You must purchase
and install the xSec software
module license in the
controller.
— —
point-to-point
MAC address of the controller
that is the xSec tunnel
termination point, and the 16-
byte shared key used to
authenticate the controllers to
each other. The key must be
the same on both controllers.
— —
allowed vlan
VLANs that are allowed on the
xSec tunnel.
— —
mtu
(Optional) MTU size for the
xSec tunnel.
— —
vlan
xSec VLAN ID. For controller-
to-controller communications,
both controllers must belong
to the same VLAN.
1-4094 —
Usage Guidelines
Use this command to configure settings for the controller interface, including duplex, LLDP and switchport
settings. You can execute the show port status command to obtain information about the interfaces
currently available on the controller. This command also displays the port-security error, if any.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide interface fastethernet | gigabitethernet | 455