Concept Guide

Parameter Description Range Default
However, if you execute the trusted vlan
<word>command, it overrides any earlier
untrusted VLANs or a range of untrusted VLANs
and creates a new set of trusted VLANs.
NOTE: A port supports a user VLAN range from 1-
4094. If you want to set all VLANs (1-4094) on a
port as untrusted then mark the port itself as
untrusted. By default the port and all its associated
VLANs are trusted.
xsec
Enables and configures the Extreme Security
(xSec) protocol.
NOTE: You must purchase and install the xSec
software module license in the controller.
— —
point-to-point
MAC address of the controller that is the xSec
tunnel termination point, and the 16-byte shared
key used to authenticate the controllers to each
other. The key must be the same on both
controllers.
— —
allowed vlan
VLANs that are allowed on the xSec tunnel. — —
mtu
(Optional) MTU size for the xSec tunnel. — —
vlan
xSec VLAN ID. For controller-to-controller
communications, both controllers must belong to
the same VLAN.
1-4094 —
Usage Guidelines
A port channel allows you to aggregate ports on a controller. You can configure a maximum of 8 port channels
per supported controller with a maximum of 8 interfaces per port channel.
Note the following when setting up a port channel between a controller and a Cisco switch (such as a Catalyst
6500 Series Switch):
l There must be no negotiation of the link parameters.
l The port-channel mode on the Cisco switch must be “on”.
Example
The following command configures a port channel:
(host) (config) #interface port channel 7
add fastethernet 1/1
add fastethernet 1/2
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide interface port-channel | 462