Concept Guide

lacp group
lacp group <group_number> mode {active | passive}
Description
Enable Link Aggregation Control Protocol (LACP) and configure LACP on the interface.
Parameter Description
<group_number>
Enter the link aggregation group (LAG) number.
Range: 0-7
mode {active | passive}
Enter the keyword mode followed by either the keyword active or passive.
l Active mode—the interface is in active negotiating state. LACP runs on
any link that is configured to be in the active state. The port in an active
mode also automatically initiates negotiations with other ports by
initiating LACP packets.
l Passive mode—the interface is not in an active negotiating state. LACP
runs on any link that is configured in a passive state. The port in a
passive mode responds to negotiations requests from other ports that
are in an active state. Ports in passive state respond to LACP packets.
Usage Guidelines
LACP is disabled by default; this command enables LACP. If the group number assigned contains static port
members, the command is rejected.
Related Command
Command Description
show lacp
View the LACP configuration status
show lacp sys-id
View the LACP system ID information
show interface port-
channel
View information on a specified port channel interface
Command History
Release Modification
ArubaOS 3.4.1 Command introduced
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide lacp group | 559