Concept Guide

738| rf dot11a-radio-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Range Default
l Level-2: noise and spur immunity. This
is the default setting
l Level-3: level 2 and weak OFDM
immunity.
l Level-4: level 3 and FIR immunity.
l Level-5: disable PHY reporting.
NOTE: Do not raise the noise immunity
feature’s default setting if the channel-
reuse-threshold on page 736 feature is
also enabled. A level-3 to level-5 Noise
Immunity setting is not compatible with
the Channel Reuse feature.
maximum-distance
Maximum distance between a client and
an AP or between a mesh point and a
mesh portal, in meters. This value is used
to derive ACK and CTS timeout times. A
value of 0 specifies default settings for this
parameter, where timeouts are only
modified for outdoor mesh radios which
use a distance of 16km.
The upper limit for this parameter varies,
depending on the 20/40 MHz mode for a 5
GHz frequency band radio:
l 20MHz mode: 58km
l 40MHz mode: 27km
Note that if you configure a value above
the supported maximum, the maximum
supported value will be used instead.
Values below 600m will use default
settings.
0-57km
(40MHz
mode)
0-27km
(20MHz
mode)
0 meters
mgmt-frame-throttle-
interval
Averaging interval for rate limiting
management frames in seconds. Zero
disables rate limiting.
Note: This parameter only applies to
AUTH and ASSOC/RE-ASSOC
management frames.
0-60 1 second
interval
mgmt-frame-
throttle-limit
Maximum number of management
frames allowed in each throttle interval.
NOTE: This parameter only applies to
AUTH and ASSOC/RE-ASSOC
management frames.
0-999999 20 frames
per interval
mode
One of the operating modes for the AP. ap-mode