Concept Guide

Table Of Contents
show ap-name
show ap-name [<ap-name>]
Description
Show a list of AP names. Include the <ap-name> parameter to display detailed configuration information for
that AP.
Syntax
Parameter Description
<ap-name>
The name of an AP.
Example
This first example shows that the controller has eight registered APs. The Name column lists the names of each
registered AP. Note that APs are all user-defined, so they will not have an entry in the Profile Status column.
(host) #show ap-name
AP name List
------------
Name Profile Status
---- --------------
mp3
sw-ad-11
sw-ad-13sw-ad-15sw-ad-17sw-ad-18sw-ad-19sw-ad-3
Total: 8
Include an AP name to display a complete list of configuration settings for that AP. If the AP has default
settings, the value may appear as N/A. The AP in the example below has all default profile settings.
(host) #show ap-group corp1
AP name "mp3"
-------------
Parameter Value
--------- -----
Virtual AP N/A
Excluded Virtual AP N/A
802.11a radio profile N/A
802.11g radio profile N/A
Wired AP profile N/A
Ethernet interface 0 link profile N/A
Ethernet interface 1 link profile N/A
AP system profile N/A
VoIP Call Admission Control profile N/A
802.11a Traffic Management profile N/A
802.11g Traffic Management profile N/A
Regulatory Domain profile N/A
RF Optimization profile N/A
RF Event Thresholds profile N/A
IDS profile N/A
Mesh Radio profile N/A
Mesh Cluster profile N/A
Excluded Mesh Cluster profile N/A
The output of this command includes the following parameters:
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap-name | 944