Concept Guide

show ap arm client-match probe-report
show ap arm client-match probe-report
ap-name <name>
ip-addr <ipaddr>
ip6-addr <ip6-addr>
assoc
phy-type 802.11a|802.11b|80211g
Description
If the client match feature is enabled, the output of this command displays the client probe report for the
specified AP.
Syntax
Parameter Description
ap-name <name>
Name of the AP for which you want to view a client report.
ip-addr <ip-addr>
IPv4 address of an AP for which you want to view a client probe report.
ip6-addr <ip6-addr>
IPv6 address of an AP for which you want to view a client probe report.
assoc
Show information for associated clients only.
phy-type
Show information for one of the following phy types:
l 802.11a
l 802.11b
l 80211g
Usage Guidelines
APs using the client match feature maintain a table of clients that have sent probe requests, and the signal-to-
noise ratio (SNR) of the frame the AP received from the client. The AP sends these reports to the controller ever
30 seconds, and the controller uses the information in these reports to steer each client to its optimal AP.
Example
(host)#show ap arm client-match probe-report ap-name <ap-name>
AP Client Probe Report for Wifi0
--------------------------------
Client MAC Signal Assoc Sec since Sec since Last heard
last heard last reported
---------- ------ ----- ------------ ---------- ----------
00:24:d7:40:ca:88 15 0 49 10 Wed Apr 10 01:20:46 2013
00:26:c6:4d:2b:74 21 0 23 10 Wed Apr 10 01:21:12 2013
00:1e:65:2b:7a:3e 23 0 55 10 Wed Apr 10 01:20:40 2013
74:e5:43:4b:3b:ff 34 0 20 10 Wed Apr 10 01:21:15 2013
AP Client Probe Report for Wifi1
--------------------------------
Client MAC Signal Assoc Sec since Sec since Last heard
last heard last reported
---------- ------ ----- ------------ -------------- ----------
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap arm client-match probe-report | 960