Concept Guide

Client IP Assignment Client VLAN Assignment
Virtual Controller
assigned
If Virtual Controller assigned is selected for client IP assignment, the VC creates a
private subnet and VLAN on the W-IAP for the wireless clients. The network address
translation for all client traffic that goes out of this interface is carried out at the
source. This setup eliminates the need for complex VLAN and IP address management
for a multisite wireless network.
On selecting this option, the following client VLAN assignment options are displayed:
l Default—When selected, the default VLANas determined by the VC is assigned for
clients.
l Custom—When selected, you can specify a custom VLAN assignment option. You
can select an existing DHCP scope for client IP and VLAN assignment or you can
create a new DHCP scope by selecting New. For more information on DHCP
scopes, see Configuring DHCP Scopes on page 207.
Network assigned
If Network assigned is selected, you can specify any of the following options for the
Client VLAN assignment.
l Default—On selecting this option, the client obtains the IP address in the same
subnet as the W-IAPs. By default, the client VLAN is assigned to the native VLAN on
the wired network.
l Static—On selecting this option, you need to specify any one of the following: a
single VLAN, a comma separated list of VLANS, or a range of VLANs for all clients
on this network. Select this option for configuring VLAN pooling.
l Dynamic—On selecting this option, you can assign the VLANs dynamically from a
Dynamic Host Configuration Protocol (DHCP) server. To create VLAN assignment
rules, click New to assign the user to a VLAN. In the New VLAN Assignment Rule
window, enter the following information:
l Attribute—Select an attribute returned by the RADIUS server
during authentication.
l Operator—Select an operator for matching the string.
l String—Enter the string to match .
l VLAN—Enter the VLAN to be assigned.
Table 22: IP and VLAN Assignment for WLAN SSIDClients
4. Click Next to configure security settings for the Employee network. For more information, see Configuring
Security Settings for a WLAN SSID Profile on page 86.
In the CLI
To manually assign VLANs for WLAN SSID users:
(Instant AP)(config)# wlan ssid-profile <name>
(Instant AP)(SSID Profile <name>)# vlan <vlan-ID>
(Instant AP)(SSID Profile <name>)# end
(Instant AP)# commit apply
To create a new VLAN assignment rule:
(Instant AP)(config)# wlan ssid-profile <name>
(Instant AP)(SSID Profile <name>)# set-vlan <attribute> {{contains|ends-with|equals|matches-
regular-expression|not-equals|starts-with} <operand> <vlan>|value-of}
(Instant AP)(SSID Profile <name>)# end
(Instant AP)# commit apply
Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide Wireless Network Profiles | 85