Deployment Guide

10 Dell Networking W-IAP277 Outdoor Instant Access Point | Installation Guide
AC Power Cable Connector PIN OUT
Figure 8
AC power cable connector
Connecting the Power Cable to the IAP
1. Remove the weatherproof cap on the power interface.
2. Insert the power cable connector into the power interface and hand-fasten the locknut.
Verifying Post-Installation Connectivity
The integrated LEDs on the IAP can be used to verify that the IAP is receiving power and initializing successfully
(see Table 1 and Table 2). Refer to the Dell Networking W-Series Instant Quick Start Guide for details on
verifying post-installation network connectivity.
HotNeutral
Ground