Concept Guide

Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide Initial Configuration Tasks | 77
Chapter 6
Initial Configuration Tasks
This chapter describes the general configuration tasks to perform when a W-IAP is set up.
l Basic Configuration Tasks on page 77
l Additional Configuration Tasks on page 80
Basic Configuration Tasks
This section describes the following basic configuration tasks that can be performed in the System>General
tab after a W-IAP is set up:
l Modifying the W-IAP Name on page 77
l Updating Location Details of a W-IAP on page 78
l Configuring Virtual Controller IP Address on page 78
l Configuring a Timezone on page 79
l Configuring a Preferred Band on page 78
l Configuring an NTP Server on page 79
l Enabling AppRF Visibility on page 80
The following figure shows an example for the basic configuration settings in the System>General tab:
For information on Dynamic RADIUS proxy configuration, see Configuring Authentication Servers on page 159.
Modifying the W-IAP Name
You can change the name of a W-IAP by using the Instant UI or CLI.