Concept Guide

1085| show ap debug client-table Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description
Rx_timestamp
Date and time the last packet was received from the client.
MFP status
Client is 802.11W capable/802.11W is enabled on Radio
Idle Time
Number of seconds elapsed since a packet was received from the client.
Client Health
This column shows the client health of the client and the AP radio, in the format
<client_health>/<AP-health>. These values report the quality of link between the client
and radio,
An AP’s client health is the efficiency at which that AP transmits downstream traffic to a
particular client. This value is determined by comparing the amount of time the AP
spends transmitting data to a client to the amount of time that would be required
under ideal conditions, that is, at the maximum Rx rate supported by client, with no
data retries.
A client health metric of 100% means the actual airtime the AP spends transmitting
data is equal to the ideal amount of time required to send data to the client. A client
health metric of 50% means the AP is taking twice as long as is ideal, or is sending one
extra transmission to that client for every packet. A metric of 25% means the AP is
taking four times longer than the ideal transmission time, or sending 3 extra
transmissions to that client for every packet.
Command History
Version Description
ArubaOS 3.0 Command Introduced
ArubaOS 6.3.1 The Client Health metric was introduced.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master
controllers