Concept Guide

1088| show ap debug counters Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
0 1 (1) 0 N
Total APs :6
The output of this command includes the following information:
Column Description
Name
Name of the AP.
Group
Name of the AP’s group.
IP Address
IP address of the AP.
Configs sent
Number of times configuration changes have been sent to the AP.
Configs Acked
Number of times that the AP has acknowledged receiving a configuration
change.
AP Boots Sent
Number of times reboot requests have been sent to the AP.
AP Boots Acked
Number of times that the AP has acknowledged receiving a reboot request.
Bootstraps
Number of times the AP bootstrapped since AP reboot. Bootstraps are also
known as “soft” restarts.
Total Bootstraps
Total number of times the AP bootstrapped since AP image upgrade.
Reboots
Number of times power to the AP cycled off and then on again since image
upgrade. Reboots also known as “hard” restarts.
Crash
Indicates whether or not the AP was rebooted due to a kernel crash. Use show ap
debug crash-info to view the crash signature.
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master
controllers