Concept Guide

1135| show ap debug received-config Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Active Scan Disabled
VoIP Aware Scan Enabled
Power Save Aware Scan Enabled
Load aware Scan Threshold 1250000 Bps
40 MHz intolerance Disabled
Honor 40 MHz intolerance Enabled
Legacy station workaround Disabled
Country Code US
ESSID guest
...
The output of this command includes the following information:
Parameter Description
BSSID
The BSSID of the AP.
LMS IP
The LMS IP is the IP address of the local controller used by
the AP for client data processing.
Master IP
For environments with multiple controllers, the master
controller is the central configuration and management
point for all local controllers.
Mode
Shows the operating modes for the AP.
ap-mode: Device provides transparent, secure, high-speed
data communications between wireless network devices
and the wired LAN.
am-mode: Device behaves as an air monitor to collect
statistics, monitor traffic, detect intrusions, enforce security
policies, balance traffic load, self-heal coverage gaps, etc.
QBSS Probe Response
Quality-of-service BSS (QBSS).
Native VLAN ID
The ID number of the Native VLAN.
SAP MTU
The Maximum Transmission Unit (MTU) for the GRE tunnel.
Heartbeat DSCP
DSCP value for the heartbeat traffic between the AP and the
controller.
High throughput enable (radio)
Shows if high-throughput (802.11n) features on tare
enabled or disabled on the radio.
Channel
Shows the channel number for the AP’s 802.11a/802.11n
physical layer.
Beacon Period
Shows the time, in milliseconds, between successive beacon
transmissions. The beacon advertises the AP’s presence,
identity, and radio characteristics to wireless clients.
Transmit Power
Shows the current transmission power level.