Concept Guide

show ap mesh debug current-cluster
show ap mesh debug current-cluster {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-addr>}
Description
Display information for the mesh cluster currently used by a mesh point or mesh portal.
Syntax
Parameter Description
ap-name <ap-name>
Show mesh cluster data for an AP with a specific name.
bssid <bssid>
Show mesh cluster data for a specific Basic Service Set Identifier (BSSID) on
an AP. An AP’s BSSID is usually the AP’s MAC address.
ip-addr <ip-addr>
Show mesh cluster data for an AP with a specific IP address. Enter the IP
address in dotted-decimal format.
Examples
The output of the command below shows mesh cluster profile configuration parameters for the mesh cluster
currently used by an AP named “mp2.”
(host) #show ap mesh debug current-cluster ap-name mp2
AP "mp2" Current Cluster Profile: default
-----------------------------------------
Item Value
---- -----
Cluster Name smettu-mesh
RF Band a
Encryption opensystem
WPA Hexkey N/A
WPA Passphrase ********
The output of this command includes the following information:
Column Description
Cluster Name
Name of the mesh cluster using this profile
RF band
The RF band in which the mesh point or mesh portal operates:
l g = 2.4 GHz
l a = 5 GHz
Encryption
Data encryption setting for the mesh cluster profile.
l opensystem—No authentication and encryption.
l wpa2-psk-aes—WPA2 with AES encryption using a preshared key.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap mesh debug current-cluster | 1191