Concept Guide
show ap port status
ap-name <ap-name>
bssid <bssid>
ip-addr <ip-addr>
ip6-addr <ip6-addr>
wired-mac <wired-mac>
Description
Shows the status of the AP's wired ports. The status is updated every 60 seconds.
Syntax
Parameter Description
ap-name <ap-name>
Name of the AP.
bssid <bssid>
BSSID of the AP.
ip-addr <ip-addr>
IP address of the AP.
ip6-addr <ip6-addr>
IPv6 address of the AP.
wired-mac <wired-mac>
MAC address of the AP.
Examples
The output of the command displays the wired port status of an APnamed LocalAP1. In this example, the
output is divided into multiple sections to fit better on the pages of this document. In the actual command-line
interface, it appears in a single long table.
(host) #show ap port status ap-name LocalAP1
AP "LocalAP1" Port Status (updated every 60 seconds)
--------------------------------------------------
Port MAC Type Forward Mode Admin Oper Speed Duplex 802.3az PoE STP
Portfast TX-Packets TX-Bytes RX-Packets RX-Bytes
---- --- ---- ------------ ----- ---- ----- ------ ------- --- ---
-------- ---------- -------- ---------- --------
0 9c:1c:12:c0:ab:40 GE N/A enabled up 1 Gb/s full disabled N/A N/A
N/A 593105 308049749 932290 112871941
1 9c:1c:12:c0:ab:41 GE tunnel enabled down N/A N/A N/A N/A N/A
N/A 0 0 0 0
Command History
Version Modification
ArubaOS 6.2 Command introduced.
ArubaOS 6.3 A new column STP displays the spanning tree state of the wired port.
ArubaOS 6.5 A new column Portfast displays the Portfast state of the wired port.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap port status | 1234