Concept Guide

Column Description
l generic interferer
l microwave
l microwave inverter
l video
l xbox
NOTE: For additional details about non-Wi-Fi device types shown in this
table, see Non-Wi-Fi Interferers on page 1299
ID ID number assigned to the device by the spectrum monitor or hybrid AP
radio. Spectrum monitors and hybrid APs assign a unique spectrum ID per
device type.
Cfreq Center frequency of the signal sent from the device.
Bandwidth Channel bandwidth used by the device.
Channels-affected Radio channels affected by the wireless device.
Signal-strength Strength of the signal sent from the device, in dBm.
Duty-cycle Device duty cycle. This value represents the percent of time the device
broadcasts a signal.
Add-time Time at which the device was first detected.
Update-time Time at which the device’s status was updated.
Related Commands
Command Description Mode
ap spectrum local-override
Convert an AP or AM into a
spectrum monitor by adding
it to the spectrum local-
override list.
Config mode on
master or local
controllers
rf dot11a-radio-profilemodespectrum-mode
Set a 802.11a radio so the
device operates as an
spectrum monitor, and can
send spectrum analysis
data to a desktop or laptop
client.
Config mode on
master or local
controllers
rf dot11g-radio-profilemodespectrum-mode
Set a 802.11g radio so the
device operates as an
spectrum monitor, and can
send spectrum analysis
data to a desktop or laptop
client.
Config mode on
master or local
controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap spectrum device-list | 1305