Concept Guide

show arp
show arp
Description
Show Address Resolution Protocol (ARP) entries for the controller.
Syntax
No parameters
Example
This example shows configured static ARP entries for the controller.
(host) #show arp
Protocol Address Hardware Address Interface
Internet 10.3.129.98 00:1A:1E:C0:80:28 vlan1
Internet 10.3.129.253 00:0B:86:42:35:80 vlan1
Internet 10.3.129.250 00:1A:92:45:DB:00 vlan1
Internet 10.3.129.99 00:1A:1E:C0:1C:60 vlan65
Internet 10.3.129.96 00:1A:1E:C0:80:1E vlan65
Internet 10.3.129.254 00:0B:86:02:EE:00 vlan1
The output of this command includes the following parameters:
Parameter Description
Protocol
Protocol using ARP. Although the controller will most often use ARP to
translate IP addresses to Ethernet MAC addresses, ARP may also be used
for other protocols, such as Token Ring, FDDI, or IEEE 802.11, and for IP
over ATM.
Address
IP address of the device.
Hardware Address
MAC address of the device.
Interface
Interface used to send ARP requests and replies.
Related Commands
Add a static Address Resolution Protocol (ARP) entry using the command show arp.
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms
Licensing Command Mode
All platforms Base operating system Enable and Config mode on master and
local controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show arp | 1372