Concept Guide

show branch-dhcp-pool
show branch-dhcp-pool config-group <group-name> [pool-name <pool>]
Description
The output of this command shows a summary of DHCP pool information for branch controllers.
Syntax
Parameter Description
config-group <group-name>
Name of the branch config group
pool-name <pool>
(Optional) include the name of the DHCP pool in this command to view
information only for the selected DHCP pool. If these parameters are
omitted, the output of this command shows information for all DHCP
pools associated with the branch config group.
Usage Guidelines
Each branch config group contains a branch controller DHCP address pool, which defines a range of IP
addresses allocated for branch controllers at a remote site, and the VLAN to be associated with those
addresses. A remote-node dhcp pool is configured in the branch controller mode.
Use the show branch-dhcp-pool command to view a summary of branch controller address pool
information.
Example
This example shows a summary of branch controller DHCP address pool information.
DHCP Address Pools
------------------
Start IP Address Mask Interface IP Address Is Active
---------------- ---- -------------------- ---------
192.168.20.2 255.255.255.252 192.168.20.1 Active
192.168.20.6 255.255.255.252 192.168.20.5 Active
Branch controller MAC Address Hostname
----------------------------- --------
00:0b:86:99:d6:97 Cube-7010
00:0b:86:99:89:97 7010-234
(host) #show branch-dhcp-pool config-group it pool-name controller_ip
Pool Name : controller_ip
Vlan : 20
Start IP : 192.168.20.0
End IP : 192.168.20.16
Domain Name :
Number of Hosts: 4
The output of this command includes the following parameters:
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show branch-dhcp-pool | 1388