Concept Guide

show crypto-local ipsec-map
show crypto-local ipsec [tag <ipsec-map-name>]
Description
Displays the current IPsec map configuration on the controller.
Syntax
Parameter Description
tag <ipsec-map-name>
Display a specific IPsec map.
Usage Guidelines
The command show crypto-local ipsec displays the current IPsec configuration on the controller.
Examples
The command show crypto-local ipsec-map shows the default map configuration along with any specific
IPsec map configurations.
(host) #show crypto-local ipsec-map
Crypto Map Template "sample" 5
IKE Version: 2
IKEv2 Policy: 20
Security association lifetime seconds : 300
Security association lifetime kilobytes: N/A
PFS (Y/N): N
Transform sets={default-transform }
Peer gateway: gateway.example.com
Interface: VLAN 0
Source network: 10.4.215.10/255.255.255.255
Destination network: 10.3.75.15/255.255.255.255
Pre-Connect (Y/N): Y
Tunnel Trusted (Y/N): Y
Forced NAT-T (Y/N): N
Uplink Failover (Y/N):N
IP Compression (Y/N):N
Related Commands
Command Description Mode
crypto-local ipsec-map
Use this command to configure IPsec mapping
for site-to-site VPN.
Config mode
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show crypto-local ipsec-map | 1408