Concept Guide

1449| show datapath Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Version
Description
l dpi
l session dpi
l session ipv6 dpi
l session session-id dpi
ArubaOS 6.4.1.0 The following parameters were introduced as part of the show datapath
frame command output:
l Excessive ARP Requests
l Excessive Gratuitous ARP Requests
The acl id <ACL-id> parameter was added.
ArubaOS 6.4.2.0
l The session web-cc parameter was introduced. This command displays
web-content category information about the session.
l The web-cc parameter was introduced. This command parameter
displays web-content classification table information, including the web
content category ID, reputation score, and URL.
ArubaOS 6.4.3.0
The following changes were introduced:
l The compression parameter displays datapath compression statistics.
By default, the combined statistics for all CPUs are shown.
l The output of the show datapath session command now supports the
r flag,which indicates that the session was routed through a nexthop
device defined by a nexthop-list. For more information, see ip nexthop-
list.
l The output of the show datapath cp-bwm command now displays the
rate in pps.
ArubaOS 6.5 The following parameters were introduced:
l ip-geolocation [counters]
l ip-reputation [counters|rtc]
l session ip-classification
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master or
local controllers