Concept Guide

Parameter Description
Rate limit CP session mirror traffic
Displays the traffic rate limit for session
mirrored traffic forwarded to the controller.
Rate limit CP auth process traffic
Displays the traffic rate limit for traffic forwarded
to the authentication process.
Deny inter user traffic
If enabled, this setting disables traffic between
all untrused users. You can configure user role
policies that prevent Layer-3 traffic between
users or networks but this does not block Layer-2
traffic.
Prohibit ARP Spoofing
When this option is enabled, possible arp
spoofing attacks are logged and an SNMP trap is
sent.
Stateful VOCERA Processing
VOCERA processing is disabled by default.
Stateful UA Processing
UA processing is disabled by default.
Enforce bw contracts for broadcast traffic
If enabled, bw contracts are applied ot local
subnet broadcast traffic.
Multicast automatic shaping
If enabled, enables multicast optimization and
provides excellent streaming quality regardless
of the amount of VLANs or IP IGMP groups that
are used.
Stall Detection
If enabled, triggers datapath crash on stall
detection. Applies to the to W-7200
Seriescontrollers only.
Enforce TCP Sequence numbers
If enabled, prevents data from passing between
two clients until the three-way TCP handshake
has been performed.
AMSDU Rx
Aggregated Medium Access Control Service
Data Units (AMSDU) packets are dropped if this
option is enabled.
Jumbo Frames
If enabled, supports up to 9216 bytes of payload
on the controller.
Session-tunnel FIB
Enables session tunnel based forwarding.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show firewall | 1490