Concept Guide

show ids dos-profile
show ids dos-profile <profile-name>
Description
Show an IDS Denial Of Service (DoS) Profile
Syntax
Parameter Description
<profile-name>
Name of an IDS DoS profile.
Usage Guidelines
Issue this command without the <profile-name>parameter to display an IDS DoS profile.
Examples
The example below shows that the controller has four configured DoS profiles.
((host) (config) #show ids dos-profile
IDS Denial Of Service Profile List
----------------------------------
Name References Profile Status
---- ---------- --------------
default 4
test 0
test1 1
Wizard-test 1
Wizard-test2 1
Total:5
In the example above, the Reference column indicates the number of references to the profile named in the
Name column. The Profile Status column is blank unless the rule is predefined.
The example below displays a partial output for the profile “test1”.
(host) (config) #show ids dos-profile test1
Parameter Value
--------- -----
Detect Disconnect Station Attack true
Disconnect STA Assoc Response Theshold 5
Disconnect STA Deauth and Disassoc Theshold 8
Disconnect STA Detection Quiet Time 900 sec
Spoofed Deauth Blacklist Disabled
Detect AP Flood Attack false
AP Flood Threshold 50
AP Flood Increase Time 3 sec
AP Flood Detection Quiet Time 900 sec
Detect Client Flood Attack false
Client Flood Threshold 150
Client Flood Increase Time 3 sec
Client Flood Detection Quiet Time 900 sec
Detect EAP Rate Anomaly false
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ids dos-profile | 1526