Concept Guide

show interface port-channel
show interface port-channel
Description
Displays information about a specified port-channel interface.
Syntax
Parameter Description
access-group
Displays access groups configured on this interface.
counters
Displays L2 interface counters for the specified interface.
untrusted-vlan
Displays port member vlan untrusted status.
xsec
Displays xsec configuration.
Example
The example below shows the output of show interface port-channel 0 on a controller.
(host) #show interface port-channel 6
Port-Channel 6 is administratively up
Hardware is Port-Channel, address is 00:1A:1E:00:0D:08 (bia 00:1A:1E:00:0D:08)
Description: Link Aggregate (LACP)
Spanning Tree is forwarding
Switchport priority: 0
Jumbo Support is enabled on this interface MTU 9216
Member port:
GE 0/0/4, Admin is up, line protocol is up
GE 0/0/5, Admin is up, line protocol is up
Last clearing of "show interface" counters 1 day 20 hr 32 min 43 sec
link status last changed 1 day 20 hr 29 min 58 sec
69425936 packets input, 15102169223 bytes
Received 27578 broadcasts, 0 runts, 0 giants, 0 throttles
0 input error bytes, 0 CRC, 0 frame
27568 multicast, 69398358 unicast
270782 packets output, 37271325 bytes
0 output errors bytes, 0 deferred
0 collisions, 0 late collisions, 0 throttles
Port-Channel 6 is TRUSTED
The output of this command includes the following parameters:
Parameter Description
Port-Channel 6 is...
Status of the specified port.
line protocol is...
Status of the line protocol on the specified port.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show interface port-channel | 1569