Concept Guide

show ip nat pool
show ip nat pool
Description
Display pools of IP addresses for network address translation (NAT.
Syntax
No parameters
Examples
The example below shows the current NAT pool configuration on the controller.
(host) # show ip nat pools
NAT Pools
---------
Name Start IP End IP DNAT IP
---- -------- --------- -------
2net 2.1.1.1 2.1.1.125
The output of this command includes the following parameters:
Parameter Description
Name
Name of the NAT pool.
Start IP
IP address that defines the beginning of the range of source NAT addresses in the pool.
End IP
IP address that defines the end of the range of source NAT addresses in the pool.
DNAT IP
Destination NAT IP address, if defined.
Related Commands
Command Description
ip nat This command configures a pool of IP addresses for network address translation (NAT).
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All
platforms
Though this command is available in the operating system,
you must have a PEFNG license to configure a NAT pool.
Available in Config or
Enable mode on master or
local controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ip nat pool | 1606