Concept Guide

show ip ospf
show ip ospf
database
debug route
interface [tunnel|vlan] <id>
neighbor
rapng-vpn aggregate-routes <ip-addr>
redistribute
subnet
Description
Display statistics and configuration information for the Open Shortest Path First (OSPF) routing protocol.
Syntax
Parameter Description
database
Show database information for the OSPF protocol.
debug route
Show debugging information for OSPF routes.
interface [tunnel|vlan] <id>
Display the status of OSPF on an individual interface by specifying a
tunnel or VLAN ID number. The tunnel ID range is 1-16777215.
neighbor
Display data for OSPF neighboring routers.
rapng-vpn
Display IAP-VPN information.
aggregate-routes <ip-addr>
Display IAP-VPN aggregate route information.
redistribute
Display OSPF route distribution information.
subnet
Display the subnets manually added to the Subnet Exclude List via
the router ospf subnet exclude <addr> <mask>command.
Example
If you issue this command without any of the optional parameters described in the table above, the show ip
ospf command will display general router and area settings for the OSPF.
(host) (config-subif)# show ip ospf
OSPF is currently running with Router ID 123.45.110.200
Number of areas in this router is 1
Area 10.1.1.0
Number of interfaces in this area is 2
Area is totally stub area
SPF algorithm executed 0 times
The output of this command includes the following parameters.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ip ospf | 1610