Concept Guide

ManualsBrandsDell ManualsAccess PlatformsW-Series 304/305 Access Points

1711

show log system

show log system{[<number>][all]}

Description

Show the controller’s system logs.

Syntax

Parameter Description

Start displaying the log output from the specified number of lines from the

end of the log.

all

Shows all the system logs for the controller.

Example

This example shows the controller’s last ten system logs.

(host) #show log system 10

Mar 5 11:55:59 :316073: <DBUG> |wms| Received New AP Message: AP 00:0b:86:b5:87:c2 Status 1

Num-WM 0

Mar 5 11:55:59 :316083: <DBUG> |wms| mysql: UPDATE ap_table SET ssid='qa-abu-customerissue',

current_channel='11', type='generic-ap', ibss='no', phy_type='80211g', rap_type='interfering',

match_mac='00:00:00:00:00:00', power_level='255', status='up' WHERE id='71575' ;

Mar 5 11:55:59 :316029: <DBUG> |wms| Sending message to Probe: IP:10.3.49.253 Msg-

Type:PROBE_RAP_TYPE AP 00:0b:86:b5:87:c2 Type:1

Mar 5 11:55:59 :316036: <DBUG> |wms| Received New STA Message: MAC 00:0b:86:b5:87:c2 Status

Mar 5 11:55:59 :316032: <DBUG> |wms| STA Probe: ADD Probe 00:0b:86:a2:e7:40 for STA

00:0b:86:b5:87:c2

Mar 5 11:56:00 :399814: <DBUG> |fpapps| PoE: RAN THRU ITERATION 2

Mar 5 11:56:00 :326001: <DBUG> |AP 1.1.1@10.3.49.253 sapd| AM: am_read_bss_data_stats: radio

0: pktsIn 0 pktsOut 0 bytesIn 0 bytesOut 0

Mar 5 11:56:00 :326001: <DBUG> |AP 1.1.1@10.3.49.253 sapd| AM: am_read_bss_data_stats: radio

0: pktsIn 0 pktsOut 52107 bytesIn 0 bytesOut 18143486

Mar 5 11:56:01 :326001: <DBUG> |AP 1.1.1@10.3.49.253 sapd| AM: MPPS 2722 CPPS 338 PKTS

452036609 BYTES 2062458092 INTR 334327351

Mar 5 11:56:02 :399814: <DBUG> |fpapps| PoE: Evaluating port 1/5 rv is 0 and crv is 1

state :3

Command History

This command was available in ArubaOS 3.0.

Command Information

Platforms Licensing Command Mode

All platforms Base operating system Available in Enable and Config modes.

Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show log system | 1712