Concept Guide

show rf am-scan-profile
show rf am-scan-profile [<profile-name>]
Description
Display the Air Monitor (AM) scanning profile list. Optionally display parameter and values of a specified Air
Monitor profile.
Syntax
Parameter Description
<profile-name>
Name of this instance of the profile.
Usage Guidelines
Enter the basic show command to view a list of profiles, the number of profiles and the profile status. For
example:
(host) #show rf am-scan-profile
AM Scanning profile List
------------------------
Name References Profile Status
---- ---------- --------------
default 9
north 0
Total:2
Example
In the example above, their are two profile names; default and north. The Reference column indicates the
number of references to this profile name. The Profile Status column is blank unless the profile is predefined.
Optionally, you can enter a profile name to view the parameters for that profile. For example:
(host) #show rf am-scan-profile default
AM Scanning profile "default"
-----------------------------
Parameter Value
--------- -----
Scan Mode all-reg-domain
Dwell time: Active channels 500
Dwell time: Regulatory Domain channels 250
Dwell time: non-Regulatory Domain channels 200
Dwell time: Rare channels 100
The explanation of the display output is described in the table below.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show rf am-scan-profile | 1836