Concept Guide

184| ap mesh-radio-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Range Default
clone
Name of an existing mesh radio profile
from which parameter values are copied.
eapol-rate-opt
Use a more conservative rate for more
reliable delivery of EAPOL frames.
enabled
disabled
disabled
g-tx rates
Indicates the transmit rates for the
802.11b/g radio.
The AP attempts to use the highest
transmission rate to establish a mesh link.
If a rate is unavailable, the AP goes
through the list and uses the next highest
rate.
1, 2, 5, 6, 9,
11, 12, 18,
24, 36, 48,
54
1, 2, 5, 6, 9,
11, 12, 18,
24, 36, 48,
54 Mbps
heartbeat-
threshold
Indicates the maximum number of
heartbeat messages that can be lost
between neighboring mesh nodes.
1-255 10
hop-count
Indicates the maximum hop count from
the mesh portal.
1-32 8
link-threshold
Indicates the minimal RSSI value. If the
RSSI value is below this threshold, the link
may be considered a sub-threshold link. A
sub-threshold link is a link whose average
RSSI value falls below the configured
threshold.
If this occurs, the mesh node may try to
find a better link on the same channel and
cluster (only neighbors on the same
channel are considered).
The supported threshold is hardware
dependent, with a practical range of 10-
90.
hardware
dependent
12
mesh-ht-ssid-profile
High-throughput SSID Profile for the mesh
feature.
default
max-retries
Maximum number of times a mesh node
can re-send a packet.
0-15 4 times
mesh-mcast-opt
Enables or disables scanning of all active
stations currently associated to a mesh
point to select the lowest transmission
rate based on the slowest connected
mesh child.
When enabled, this setting dynamically
adjusts the multicast rate to that of the
slowest connected mesh child. Multicast
frames are not sent if there are no mesh
children.
enabled