Concept Guide

show switches
show switches [all | regulatory | state {complete | incomplete | inprogress | required} |
summary ]
Description
Displays the details of controllers connected to the master controller, including the master controller itself.
Syntax
Parameter
Description
all
List of all controllers.
regulatory
Displays information about the currently active regulatory file.
state
Configuration status of all controllers.
summary
Status of all controllers connected to the master.
Example
The output of this command shows that there is a single local controller connected to the master controller.
(host) # show switches all
All Switches
------------
IP Address Name Location Type Version Status Configuration State
Config Sync Time (sec)
---------- ---- -------- ---- ------- ------ -------------------
----------------------
10.16.12.1 r-wing-94 Building1.floor1 master 6.0.0.0_13782 up UPDATE SUCCESSFUL
0192.0.2.12 CorpA2400 Building1.floor1 master 6.0.0.0_13782 up UPDATE SUCCESSFUL
0
The following command displays information about branch controllers defined using a branch config group on
a master controller. In the example below, the table in the command output has been divided into two sections
to better fit on this document. In the ArubaOS command-line interface, this output appears in a single, wide
table.
(host) (config) #show switches branch
All Branch Controllers
----------------------
IP Address MAC Hostname Model Version Status
---------- --- -------- ----- ------- ------
172.16.0.254 00:1a:1e:00:56:68 host DellW-7210 6.4.3.0_48786 up
Branch Group Configuration State Branch Config ID Uptime
------------ ------------------- ---------------- ------
branch1 UPDATE SUCCESSFUL 3 7d 21h 20m
The output of the previous command includes the following parameters:
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show switches | 1909