Manualshelf

Concept Guide

ManualsBrandsDell ManualsAccess PlatformsW-Series 304/305 Access Points
1921192219231924192519261927192819291930
show tunneled-node
show tunneled-node [state|database]
Description
Displays the state of the tunneled node and lists all tunneled nodes connected to the controller.
Syntax
No parameters.
Example
The output of this command shows the tunneled node state.
(host) # show tunneled-node state
Tunneled Node State
---------
IP MAC port state vlan tunnel inactive-time
-- --- --- ----- ---- ------ -------------
192.168.123.14 00:0b:86:40:32:40 0/0/3 complete 10 9 1
192.168.123.14 00:0b:86:40:32:40 0/0/2 complete 10 10 1
192.168.123.14 00:0b:86:40:32:40 0/0/0 complete 10 11 1
On the tunneled node client:
(host) #show tunneled-node state
Tunneled Node State
-------------------
IP MAC port state vlan tunnel inactive-time
-- --- --- ----- ---- ------ -------------
192.168.123.16 00:0b:86:40:32:40 0/0/3 complete 10 21 0
192.168.123.16 00:0b:86:40:32:40 0/0/2 complete 10 9 0
192.168.123.16 00:0b:86:40:32:40 0/0/0 complete 10 13 0
Command History
Release Modification
ArubaOS 3.0 Command introduced.
ArubaOS 6.1 The command name was changed to tunneled-node. The database
parameter was added.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config or Enable mode on master or
local controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show tunneled-node | 1928