Concept Guide

show whitelist-db rap-master-switch-list
show whitelist-db rap-local-switch-list [mac-address <mac-address>]
Description
Display the remote AP whitelist master switch list on local controllers with remote APs
Syntax
Parameter Description
mac-address <mac-address>
MAC address of the local controller whose data you want to view.
Usage Guidelines
When your network has with both master and local controllers, each local controllerwith associated remote APs
has a master switch whitelist which contains the IP and MAC addresses of its master controller. If your network
has a redundant master controller, then this whitelist will contain more than one entry.
To view information for a single master controller, use the command show whitelist-db rap-master-switch-
list mac-address <mac-address>. To view a list of all master controllers, use the command show whitelist-
db rap-master-switch-list.
Example
The following command shows that the local controllers have a single master controller with the IP address
192.0.2.143. The output in the example below has been divided into sections to better fit on the pages of this
document. In the ArubaOS CLI, the output appears in a single, long table.
Active MAC-Address IP-Address Sequence Number Remote Sequence
Number
------- ----------- ---------- --------------- ---------------
1 00:0b:86:51:a5:4c 192.0.2.14 2 2
NULL Update Count Local Purge Remote Purge Remote Last-Seq Last Update Sent
----------------- ----------- ------------ --------------- ----------------
0 0 0 1 Mon May 4 12:44:24
0
Last Update Received
--------------------
Mon May 4 12:44:20
Whitelist Entries: 1
The output of this command includes the following information:
Parameter Description
Active
Shows if the controller is active on the network.
l 1: Active
l 0: Inactive
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show whitelist-db rap-master-switch-list | 2050