Concept Guide

2158| snmp-server Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Range Default
trap
Source IP address of SNMP traps. — disable
d
disable
Disables an SNMP trap. You can get a list of valid trap
names using the show snmp trap-list command.
— —
enable
Enables an SNMP trap. — —
source
Enter the source IPv4/IPv6 Address address for sending
traps.
— —
udp-port
The port number to which notification messages are sent. — 162
user
Configures an SNMPv3 user profile for the specified
username.
— —
auth-prot
Authentication protocol for the user, either HMAC-MD5-98
Digest Authentication Protocol (MD5) or HMAC-SHA-98
Digest Authentication Protocol (SHA), and the password for
use with the designated protocol.
MD5/SHA SHA
priv-prot
Privacy protocol for the user, either Advanced Encryption
Standard (AES) or CBC-DES Symmetric Encryption Protocol
(DES), and the password for use with the designated
protocol.
AES/DES DES
Usage Guidelines
This command configures SNMP on the controller only. You configure SNMP-related information for APs in an
SNMP profile which you apply to an AP group or to a specific AP. To configure SNMP hostname, contact, and
location information for the controller, use the hostname, syscontact, and syslocation commands.
Example
The following command configures an SNMP trap receiver:
(host) (config) #snmp-server host 191.168.1.1 version 2c 12345678
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.3.1 The stats parameter was introduced
ArubaOS 6.4 The IPv6 Address parameter was introduced.