Concept Guide

2273| wlan bcn-rpt-req-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter
Description Range Default
interface <interface>
This field is used to specify the
radio interface for transmitting
the Beacon Report Request
frame.
0-1 1
measure-dur-mandatory
This value is used to set the
"Duration Mandatory" bit of the
Measurement Request Mode
field of the Beacon Report
Request frame.
— Disabled
measure-duration <measure-duration>
This value is used to set the
Measurement Duration field in
the Beacon Report Request
frame. The Measurement
Duration is set to the duration of
the requested measurement. It
is expressed in units of TUs.
0 –
65535
0
measure-mode
Indicates the mode used for the
measurement. The valid
measurement modes are:
active-all-ch
active-ch-rpt
beacon-table
passive
—
beacon-
table
no
Negates any configured
parameter.
— —
random-interval <random-interval>
This value is used to set the
Randomization Interval field in
the Beacon Report Request
frame. The Randomization
Interval is used to specify the
desired maximum random delay
in the measurement start time. It
is expressed in units of TUs
(Time Units). A Randomization
Interval of 0 in a measurement
request indicates that no
random delay is to be used.
0 –
65535
0
reg-class {1|12}
This option is used to specify the
Regulatory Class field in the
Beacon Report Request frame.
For
802.11b
/g
bands,
12. For
802.11a,
use 1
—