Concept Guide

Description Range Default
Use this parameter instead of the local
probe request threshold parameter to
filter out low SNR authentication request.
CAUTION: Use this parameter with
caution. Consult technical support before
configuring this parameter.
battery-boost
Converts multicast traffic to unicast
before delivery to the client, thus
allowing you to set a longer DTIM
interval. The longer interval keeps
associated wireless clients from
activating their radios for multicast
indication and delivery, leaving them in
power-save mode longer and thus
lengthening battery life.
NOTE: This parameter requires the
PEFNG license. This parameter should
not be enabled if you plan on using the
Push-To-Talk feature for Polycom
SpectraLink devices.
— disabled
clone
Name of an existing SSID profile from
which parameter values are copied.
— —
deny-bcast
When a client sends a broadcast probe
request frame to search for all available
SSIDs, this option controls whether or not
the system responds for this SSID. When
enabled, no response is sent and clients
have to know the SSID in order to
associate to the SSID. When disabled, a
probe response frame is sent for this
SSID.
— disabled
disable-probe-retry
Enable or disable battery MAC level
retries for probe response frames. By
default this parameter is enabled, which
mean that MAC level retries for probe
response frames is disabled.
NOTE: This parameter is not supported
for W-AP200 Series, W-AP210 Series, W-
AP220 Series, W-AP270 Series access
points.
enabled
dot11r-profile
Associates the dot11r-profile with the
SSID profile.
— —
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide wlan ssid-profile | 2342