Concept Guide

243| ap-name Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Default
dot11a-traffic-mgmt-profile
Configures bandwidth allocation. See wlan traffic-
management-profile on page 2352.
—
dot11g-radio-
profile
Configures 802.11g radio settings for the AP group;
contains the ARM profile. See rf dot11a-radio-profile
on page 733.
“default”
dot11g-traffic-
mgmt-profile
Configures bandwidth allocation. See wlan traffic-
management-profile on page 2352.
—
enet0-profile
Configures the duplex and speed of the Ethernet 0
interface on the AP. See ap enet-link-profile on page
162.
“default”
enet1-profile
Configures the duplex and speed of the Ethernet 1
interface on the AP. See ap enet-link-profile on page
162.
“default”
event-thresholds-profile
Configures Received Signal Strength Indication
(RSSI) metrics. See rf event-thresholds-profile on
page 758.
“default”
exclude-mesh-cluster-profile-ap
Excludes the specified mesh cluster profile from this
AP.
The Secure Enterprise Mesh license must be
installed.
—
exclude-virtual-ap
Excludes the specified virtual AP profiles from this
AP.
ids-profile
Configures Dell’s Intrusion Detection System (IDS).
See ids profile on page 424.
“default”
mesh-cluster-profile
Configures the mesh cluster profile for the AP (mesh
node). There is a “default” mesh cluster profile;
however, it is not applied until you provision the
mesh node. See ap mesh-cluster-profile on page
175.
The Secure Enterprise Mesh license must be
installed.
“default”
priority
Configures the priority of the mesh cluster profile. If
more than two mesh cluster profiles are configured,
mesh points use this number to identify primary and
backup profile(s).
The supported range of values is 1-16. The lower the
number, the higher the priority.
1