Concept Guide

configure terminal
configure terminal
Description
This command allows you to enter configuration commands.
Syntax
No parameters.
Usage Guidelines
Upon entering this command, the enable mode prompt changes to:
(host) (config) #
To return to enable mode, enter Ctrl-Z or exit.
Example
The following command allows you to enter configuration commands:
(host) # configure terminal
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable mode on master controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide configure terminal | 289