Concept Guide

controller-ip
controller-ip [loopback|vlan <VLAN ID>]
no ...
Description
This command sets the controller IP to the loopback interface address or a specific VLAN interface address.
Syntax
Parameter
Description Default
loopback
Sets the controller IP to the loopback interface. disabled
vlan
Set the controller IP to a VLAN interface. —
VLAN ID
Specifies the VLAN interface ID. —
Usage Guidelines
This command allows you to set the controller IP to the loopback interface address or a specific VLAN interface
address. If the controller IP command is not configured then the controller IP defaults to the loopback
interface address. If the loopback interface address is not configured then the first configured VLAN interface
address is selected. Generally, VLAN 1 is the factory default setting and thus becomes the controller IP address.
Example
The following command sets the controller IP address to VLAN interface 6.
(host) (config) #controller-ip vlan 6
Related Commands
(host) (config) #show controller-ip
Command History
This command was introduced in ArubaOS 3.4
Command Information
Platform License Command Mode
Available on all platforms Base operating system Config mode on master controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide controller-ip | 292