Concept Guide

Parameter Description Range Default
max-unassociated-stations
Maximum number of unassociated
stations.
NOTE: This parameter is currently
available on W-AP220 Series access
points only.
NOTE: Configure this parameter under
the supervision of Dell Technical
Support.
256-
4096
256
min-pot-ap-beacon-rate
Minimum beacon rate acceptable from a
potential AP, in percentage of the
advertised beacon interval.
0-100 25%
min-pot-ap-monitor-time
Minimum time, in seconds, a potential
AP has to be up before it is classified as
a real AP.
2-
36000
2
second
s
mobility-manager-rtls
Enable/disable RTLS communication with
the configured mobility-manager
enable
d
disable
d
disable
d
mon-stats-update-interval
Time interval, in seconds, for AP to
update the switch with stats for
monitored devices. Minimum is 60.
60-
360000
second
s
60
second
s
no
Negates any configured parameter. — —
packet-snr-threshold
Set the packet Signal to Noise Ratio
(SNR) threshold. All packets with SNR
below this threshold is dropped from IDS
and ARM processing.
No packets are dropped if the threshold
is set to 0.
NOTE: Configure this parameter under
the supervision of Dell Technical
Support.
0-90 dB 0
send-adhoc-info-to-controller
Enable or disable sending adhoc
information to the controller from the
AP.
enable
disable
disable
signature-quiet-time
After a signature match is detected, the
time to wait, in seconds, to resume
checking.
60-
360000
second
s
900
second
s
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide ids general-profile | 416