Concept Guide

Parameter Description Range Default
in
Applies ACL to interface’s
inbound traffic.
— —
out
Applies ACL to interface’s
outbound traffic.
— —
session
Applies session ACL to
interface and optionally to a
selected VLAN associated with
this port.
— —
jumbo
Enables or disables jumbo
frame MTU configured via
firewall on a port.
— disabled
lacp
Configures an LACP
functionality on an interface.
— —
group <id> mode
[active|passive]
Sets a number for the link
aggregation group and the
LACPmode on the interface.
Active—Enables
LACPunconditionally
Passive—Enables LACPonly
when an LACPdevice is
detected
0—7 —
port-priority
Sets the LACPpriority value on
the interface
1—65535 —
timeout [long|short]
Sets the LACPtimeout to long
or short value on the
interface.
long—timeout set to long
value, that is 90 secs.
short—timeout set to short
value, that is 3 secs.
— —
lldp
Configures an LLDP
functionality on an interface.
— —
fast-transmit-counter
<1-8>
Set the number of the LLDP
data units sent each time fast
LLDP data unit transmission is
triggered
1-8 4
fast-transmit-interval
<1-3600>
Set the LLDP fast transmission
interval in seconds.
1-3600 1
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide interface fastethernet | gigabitethernet | 451