Concept Guide

476| interface vlan Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Range Default
address
Configures the IP address for this interface,
which can be one of the following:
<ipaddr> <netmask>
l dhcp-client: use DHCP to obtain the IP
address
l internal: IP address allocated from the
branch group config.
l pppoe: use PPPoE to obtain the IP address
— —
helper-address
IP address of the DHCP server for relaying
DHCP requests for this interface. If the DHCP
server is on the same subnetwork as this VLAN
interface, you do not need to configure this
parameter.
— —
igmp
Enables IGMP and/or IGMP snooping on this
interface.
— —
local-proxy-arp
Enables local proxy ARP. — —
nat inside
Enables source network address translation
(NAT) for all traffic routed from this VLAN.
CAUTION: All ports on the controller are
assigned to VLAN 1 by default. Do not enable
the nat inside option for VLAN 1, as this will
prevent IPsec connectivity between the
controller and its IPsec peers.
— —
ospf
Define an OSPF area. See ip ospf on page 527
for complete details on this command.
— —
pppoe-max-segment-site
Configures the TCP maximum segment size in
bytes.
128 —
pppoe-password
Configures the PAP password on the PPPoE
Access Concentrator for the switch.
1–80 —
pppoe-service-name
Configures the PPPoE service name. 1–80 —
pppoe-username
Configures the PAP username on the PPPoE
Access Concentrator for the switch.
1–80 —
routing
Enables layer-3 forwarding on the VLAN
interface. To disable layer-3 forwarding, you
must configure the IP address for the interface
and specify no ip routing.
— (enable
d)
ipv6
Configures IPv6 for this interface. — —